78 Installation and Service Guide: Printer Controller EB-34
Performing Backup and Restore
Restoring the system configuration
You can restore the system configuration of the EB-34 to its previous state using a previously-saved system
configuration file. For more information about the system configuration file, see page 77.
If you could not save a system configuration file, you must configure Setup. After you exit Setup and the EB-34
reboots, ask the site administrator to restore any archived settings and files. For more information, see Configuration
and Setup, which is part of the user documentation set.
To restore the system configuration from Command WorkStation
1 Launch Command WorkStation and connect to the EB-34 with Administrator privilege.
The default Administrator password is
Fiery.1 (case-sensitive), but the site administrator may have changed the
password.
2 Select Device Center > General > Tools > Backup & Restore, and click Restore > Next.
3 Select the item to restore, and click Next.
You can specify the backup file using the Browse button, or you can select a recent backup.
4 Select settings to restore and click Next.
5 Click Finish.
To restore the system configuration using Configure
1 Start a web browser and access the EB-34 by entering the server name or IP address of the EB-34.
2 From WebTools, select Configure tab > Launch Configure.
3 Log on with Administrator privileges and click OK.
The default Administrator password is
Fiery.1 (case-sensitive), but the site administrator may have changed the
password.
4 On the left side, choose Fiery Server > Restore.
5 Select the reference file and data file. Click Next.
For more information, see page 77.
6 Select settings to restore and click Next.
7 Click Reboot.
Using Fiery System Restore
Fiery System Restore allows you to create a backup of the EB-34 for quick recovery later when any problem happens.
You can restore the EB-34 either from images stored on the local hard disk, or from a USB drive. Fiery System Restore
also provides the feature of creating the scheduled backups. You can access the Fiery System Restore from the
WebTools Home tab.
To Next Page
Loading...
Need help?
General
