26 Installation and Service Guide: Printer Controller EB-34
Using the EB-34
Printing EB-34 pages
You can print the following pages:
• PS and PCL Test Pages: Lets you confirm that the EB-34-to-copier interface is working properly. The Test Pages
provide black and white and grayscale samples helpful when troubleshooting problems with the copier or the EB-
34. The following information is also listed: server name, date and time printed, and compression information.
When you print a Test Page to confirm that the EB-34-to-copier connection is operating properly, keep in mind
that:
• All patches should be visible, even though they may be very faint in the 5% and 2% range.
• Each patch set should show uniform gradation from patch to patch as the shade lightens from 100% to 0%.
Poor image quality may indicate a need to service the copier. For more information, see the documentation
provided with the copier.
If the Test Page fails to print, look up printing problems in “Table 4: EB-34 error messages and conditions” on
page 102.
• Configuration: Prints the current server and device configuration. This includes information about all current
Setup settings, and the Ethernet address of the EB-34. The Configuration page also provides version information
for the BIOS chip and information about any options installed in the EB-34.
Printing the Configuration page can be helpful during installation, Setup, and service. After installing the EB-34
(including connecting to the network) and before default settings are changed in Run Setup, you can obtain a
record of the defaults by printing the Configuration page.
• Job Log: Prints the log of the last 55 jobs by default. For more information, see Configuration and Setup.
• PS Font List: A list of all PostScript fonts resident on the HDD.
• PCL Font List: A list of all PCL fonts resident on the HDD.
• E-mail Log: Lists jobs scanned on the copier and emailed over the network as well as jobs submitted to the copier
as e-mail attachments. The log is available only when Print via E-mail is enabled in Setup. For more information,
see Configuration and Setup.
Restart Fiery Shuts down all EB-34 activity in the correct manner and then restarts. The following
options are available from the submenu that appears:
Restart Fiery Service: Resets the server software but does not reboot the entire system.
Network access to the EB-34 is temporarily interrupted and all currently processing jobs are
aborted and may be lost.
Restart System: Shuts down and then reboots the EB-34.
Shut Down: Shuts down all EB-34 activity properly.
To Next Page
Loading...
Need help?
General
