28 Installation and Service Guide: Printer Controller EB-34
Using the EB-34
To access Configure from Command WorkStation
1 In Command WorkStation, as Administrator, do one of the following:
• In the Server menu, click Configure.
• In Device Center, on the General or Users tabs, click Configure.
2 If the Fiery Setup dialog box displays, click Configure.
If you have not completed initial setup, you may want to click Fiery Setup Wizard instead. For more information, see
Configuration and Setup.
If you use the Fiery Setup Wizard (from Command WorkStation or WebTools) and click Finish at the end of the
wizard, the Fiery Setup dialog box does not display again in any location.
Starting, shutting down, restarting, and rebooting
The customer will generally leave the EB-34 on all the time. Remember that when the EB-34 is powered off, network
access to the copier is interrupted. Power off the EB-34 when you need to service it and before you remove or attach
any cables to it.
Keep in mind the following terms:
• Restart Fiery Service (on the copier touch panel)/Restart Server (on the control panel)
Resets the EB-34 server software but does not reboot the entire system. Network access to the EB-34 is temporarily
interrupted and all currently processing jobs are aborted and may be lost. If you choose this option, you may need
to wait 1 minute or more for the server software to reset.
• Restart System (on the copier touch panel)/Reboot System (on the control panel)
Shuts down all EB-34 activity properly and then reboots. Network access to the EB-34 is temporarily interrupted
and all currently processing jobs are aborted and may be lost.
• Shut Down (on the copier touch panel) and Shut Down System (on the control panel)
Shuts down all EB-34 server software and powers off the system. We recommend that you always select this option
when you want to power off the system. Network access to the EB-34 is terminated and all currently processing
jobs are aborted and may be lost.
Shutting down
If you are cycling power, wait at least 10 seconds before powering back on.
Caution:Remember that when the EB-34 is powered off, network access to the copier is interrupted. Always
obtain permission from the network administrator before you take the EB-34 off the network.
To Next Page
Loading...
Need help?
General
