70 Installation and Service Guide: Printer Controller EB-34
Replacing Parts
2 Position the hard disk drive inside the hard disk drive bracket and align the mounting holes on the hard disk drive
with the four holes in the bracket (see Figure 29 on page 68).
When correctly installed, the hard disk drive extends about an inch past the rear of the bracket.
3 Attach the hard disk drive to the bracket using the four screws that you removed earlier.
4 Place the bracket inside the chassis and secure it using the four screws that you removed earlier.
5 Connect one end of the hard disk drive data cable to the hard disk drive.
6 Connect the other end of the hard disk drive data cable to SATA1 on the motherboard (see Figure 9 on page 37).
7 Connect the power cable to the hard disk drive.
8 Reassemble the EB-34 (see page 72).
9 If you replaced the hard disk drive with a new hard disk drive, install system software (see page 78).
If a startup error displays on the control panel when you power on the EB-34, check the connections.
10 If you installed a new hard disk drive, make sure to reset the date and time in Setup. For more information, see
Configure Help.
11 Verify functionality (see page 72).
DVD drive
The DVD drive is attached to a bracket mounted to the hard disk drive bracket and the chassis. The DVD drive is used
to install system software onto the hard disk drive and archive data onto writable media.
To remove the DVD drive
1 Shut down and open the EB-34 (see pages 38).
To remove the DVD drive, you must remove the side and front panels.
2 Remove the DVD drive power/data combination cable from the back of the DVD drive.
3 Remove the screw that attaches the DVD drive bracket to the hard disk drive bracket.
4 Remove the two screws that attach the DVD drive bracket to the chassis.
Set aside the screws so that you can replace them later.
Caution:Avoid striking the motherboard as you replace the hard disk drive bracket.
Caution:Connect the thin, black SATA power cable connector to the hard disk drive. Do not connect the
white, 4-pin power cable connector. Connecting both types of power cables will damage the hard disk drive.
To Next Page
Loading...
Need help?
General
