EFI EB-34 - Page 77

77 Installation and Service Guide: Printer Controller EB-34
Performing Backup and Restore
• Command WorkStation settings (Fiery Advanced Controller Interface only)
• FreeForm/VDP resources
• Paper Catalog
• Virtual Printers
• Server Presets
• Fonts
• Job Log
Note: Those settings you do not choose are not saved for restore.
If you cannot create a configuration file, ask the site administrator to archive FreeForm masters, customer-installed
fonts, and the Job Log to removable media or a network location.
To save the system configuration using Command WorkStation
1 Ask the site administrator to print the Job Log, Server Configuration page, and Font List (if possible).
2 Launch Command WorkStation and connect to the EB-34 with Administrator privilege.
The default Administrator password is
Fiery.1 (case-sensitive), but the site administrator may have changed the
password.
3 Select Device Center > General > Tools > Backup & Restore, and click Backup > Next.
4 In the Backup & Restore dialog box, select the settings you want to back up.
5 Enter a file name and location, specify if you want to add the date to the file name, and then click Backup.
6 Click Finish.
To save the system configuration using Configure
1 Ask the site administrator to print the Job Log, Server Configuration page, and Font List (if possible).
2 Start a web browser and access the EB-34 by entering the server name or IP address of the EB-34.
3 From WebTools, select Configure tab > Launch Configure.
4 Log on with Administrator privileges and click OK.
The default Administrator password is
Fiery.1 (case-sensitive), but the site administrator may have changed the
password.
5 On the left side, choose Fiery Server > Backup.
6 In the Backup dialog box, select the settings you want to back up.
7 Enter a file name and location, specify if you want to add the date to the file name, and then click Backup.
8 Click OK.