64 Installation and Service Guide: Printer Controller EB-34
Replacing Parts
To remove the power supply
1 Shut down and open the EB-34 (see pages 38).
To access the power supply, you must remove the side panel.
2 Remove the following cables and components from the motherboard to provide room for removing the power
supply:
• Copier interface board
• Power and reset button cables
• DVD drive and hard disk drive SATA cables
• UIB cable and front panel USB port cable
3 Remove the power cable from the hard disk drive.
4 Disconnect the power supply cable from the DVD drive power and data combination cable.
5 Remove the 20-pin motherboard power cable from the motherboard.
6 Remove the 4-pin CPU power cable from the motherboard.
7 Remove the power supply cables secured by the cable harness in the chassis.
8 Remove the five screws that attach the power supply to the chassis (see Figure 27 on page 65).
Set the screws aside so that you can replace them later.
To Next Page
Loading...
