Emerson E300 Series - Page 195

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
E300 Design Guide 195
Issue Number: 1
B32
Motor Contactor Measured
Delay Time
0 to 32767 ms 0 ms RO Num
B33
Open-Loop: Transient
Inductance
0.000 to
500.000 mH
0.000 mH RW Num RA US
RFC-A: Transient
Inductance
0.000 to
500.000
mH
0.000 mH RW Num RA US
RFC-S: Transient
Inductance Ld
0.000 to 500.000 mH 0.000 mH RW Num RA US
B34 Stator Resistance 0.000000 to 1000.000000 Ω 0.000000 Ω RW Num RA US
B35 Stator Inductance 0.00 to 5000.00 mH
0.00 mH RW Num RA US
B36 Saliency Torque control
Disabled (0),
Low (1), High (2)
Disabled (0) RW Txt US
B37 No Load Lq
0.000 to 500.000 mH 0.000 mH RW Num RA US
B38
Iq Test Current For
Inductance Measurement
0 to 200 % 100 % RW Num US
B39
Phase Offset At Iq Test
Current
±90.0 ° 0.0 ° RW Num RA US
B40
Lq At The Defined Iq Test
Current
0.000 to 500.000 mH 0.000 mH RW Num RA US
B41
Id Test Current for
Inductance Measurement
-100 to 0 % -50 % RW Num US
B42
Lq At The Defined Id Test
Current
0.000 to 500.000 mH 0.000 mH RW Num RA US
B43 Estimated Lq
0.000 to 500.000 mH RO Num ND NC PT FI
B44
Low Speed Thermal
Protection Mode
0 to 1 0 RW Num US
B45 Quasi Square Enable
Off (0) or
On (1)
Off (0) RW Bit US
B46
Maximum Deadtime
Compensation
0.000 to 10.000 µs 0.000 µs RO Num NC PT US
B47
Current At Maximum
Deadtime Compensation
0.00 to 100.00 % 0.00 % RO Num NC PT US
B48
Disable Deadtime
Compensation
Off (0) or On (1) Off (0) RW Bit US
B49
Mechanical load test level
0 - 100 % 0 %
RW Num US
RW Read / Write RO Read-only Bit Bit parameter Txt Text string Date Date parameter Time Time parameter
Chr
Character
parameter
Bin Binary parameter IP IP address Mac MAC address Ver Version number SMP
Slot, menu,
parameter
Num Number parameter DE Destination ND No default value RA Rating dependent NC Non-copyable PT Protected
FI Filtered US User save PS Power-down save
Parameter
Range(Ú) Default(Ö)
Type
Open-Loop RFC-A RFC-S Open-Loop RFC-A RFC-S