Emerson E300 Series - Page 273

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
E300 Design Guide 273
Issue Number: 1
See T24 Digital I/O 01 Source/Destination (F18).
The Digital I/O Output Select parameters allow the I/O to be selected as an input (0) or an output (1). These parameters are only present for digital I/
O that can be used as an input or output.
See T24 Digital I/O 01 Output Select (F24).
See T24 Digital I/O 01 Output Select (F24).
See T24 Digital I/O 01 Source/Destination (F18).
F23 T29 Digital Input 06 Destination
Mode Open-Loop, RFC-A, RFC-S
Minimum A00 Maximum AB99
Default G32 Units
Type 16 Bit User Save Update Rate Drive reset read
Display Format Menu Param Alpha Numeric Decimal Places 3
Coding RW, DE, PT, BU
F24 T24 Digital I/O 01 Output Select
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 1
Default 1 Units
Type 1 Bit User Save Update Rate Background read
Display Format Standard Decimal Places 0
Coding RW, BU
F25 T25 Digital I/O 02 Output Select
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 1
Default 1 Units
Type 1 Bit User Save Update Rate Background read
Display Format Standard Decimal Places 0
Coding RW, BU
F26 T26 Digital I/O 03 Output Select
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit User Save Update Rate Background read
Display Format Standard Decimal Places 0
Coding RW
F27 T41 T42 Relay Output Source
Mode Open-Loop, RFC-A, RFC-S
Minimum A00 Maximum AB99
Default L05 Units
Type 16 Bit User Save Update Rate Drive reset read
Display Format Menu Param Alpha Numeric Decimal Places 3
Coding RW, PT, BU