Emerson E300 Series - Page 290

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
290 E300 Design Guide
Issue Number: 1
This is V4 speed reference and is set in mm / s.
Nominal Elevator Speed (E01) defines the maximum limit for this parameter.
This is V5 speed reference and is set in mm / s.
Nominal Elevator Speed (E01) defines the maximum limit for this parameter.
This is V6 speed reference and is set in mm / s.
Nominal Elevator Speed (E01) defines the maximum limit for this parameter.
This is V7 speed reference and is set in mm / s.
Nominal Elevator Speed (E01) defines the maximum limit for this parameter.
This is V8 speed reference and is set in mm / s.
Nominal Elevator Speed (E01) defines the maximum limit for this parameter.
G04 V4 Speed Reference
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum
VM_EX00_NOMINAL_ELEVATOR_SPEED
Default 10 Units mm / s
Type 16 Bit User Save Update Rate Background
Display Format Standard Decimal Places 0
Coding RW, VM, PT
G05 V5 Speed Reference
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum
VM_EX00_NOMINAL_ELEVATOR_SPEED
Default 100 Units mm / s
Type 16 Bit User Save Update Rate Background
Display Format Standard Decimal Places 0
Coding RW, VM
G06 V6 Speed Reference
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum
VM_EX00_NOMINAL_ELEVATOR_SPEED
Default 100 Units mm / s
Type 16 Bit User Save Update Rate Background
Display Format Standard Decimal Places 0
Coding RW, VM
G07 V7 Speed Reference
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum
VM_EX00_NOMINAL_ELEVATOR_SPEED
Default 100 Units mm / s
Type 16 Bit User Save Update Rate Background
Display Format Standard Decimal Places 0
Coding RW, VM
G08 V8 Speed Reference
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum
VM_EX00_NOMINAL_ELEVATOR_SPEED
Default 100 Units mm / s
Type 16 Bit User Save Update Rate Background
Display Format Standard Decimal Places 0
Coding RW, VM