Emerson E300 Series - Page 341

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
E300 Design Guide 341
Issue Number: 1
Drive Rated Voltage (J07) shows the voltage rating of the drive.
Drive Control Mode Active (J08) is used to hold the currently active drive mode.
This indicates the speed reference currently selected as the speed reference set point from V1 to V11 e.g. 1 = V1 Speed Reference (G01). If V11is
selected this shows that an analog reference is selected, Control Input mode (H11) = Analog Run Prmit or Analog Dir (0 or 1). A value of 0 means no
speed is currently selected.
When V1 is the creep speed in creep to floor mode:
When Creep Speed Select (G52) = V1 (1) this shows the distance from V1 Speed Reference (G01) to a stop in mm. The distance is calculated from
V1 Speed Reference (G01), Creep Stop Deceleration Rate (G17), and Creep Stop Jerk (G18).
When V1 is not the creep speed in creep to floor mode:
This indicates the distance from V1 Speed Reference (G01) to the creep speed defined by Creep Speed Select (G52) in mm. The distance is
calculated from V1 Speed Reference (G01), the creep speed defined by Creep Speed Select (G52), Deceleration Rate (G12), Run Jerk 3 (G15) and
Run Jerk 4 (G16).
Direct to floor:
In Direct to floor, Elevator Control Mode (H19) = Direct To Floor (1), this indicates the distance from V1 Speed Reference (G01) to a stop in mm. The
distance is calculated from V1 Speed Reference (G01), Deceleration Rate (G12), Run Jerk 3 (G15) and Run Jerk 4 (G16).
Value Text
0 200 V
1 400 V
2 575 V
3 690 V
J08 Drive Control Mode Active
Mode Open-Loop, RFC-A, RFC-S
Minimum 1 Maximum 4
Default Units
Type 8 Bit User Save Update Rate Background read/ write
Display Format Standard Decimal Places 0
Coding RO, TE, ND, NC, PT
Value Text
1 Open-loop
2RFC-A
3RFC-S
J09 Reference Parameter Selected
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 10
Default Units
Type 8 Bit Volatile Update Rate Background
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
J10 V1 Calculated Deceleration Distance
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 10000
Default Units
Type 16 Bit Volatile Update Rate Background
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT