Emerson X-STREAM XE User Manual

Emerson Process Management GmbH & Co. OHG6-26
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
10/2012
6.2.3 Setup Menu
6.2.3.1.2.1.1 Component Unit Setup Menu
Setup..
Display..
Measurements..
Component..
Unit..
Ch1
Component Unit
Unit: ppm
Unit Text: ppm
Span Gas Unit: ppm
Span Unit Text: ppm
Custom Factor: 1.000000
Custom Offset: 0.000000
Span Gas 50000.000 ppm
Concentration 0.000 ppm
Within this menu, congure the component´s
unit to be used for measurement results.
Set the text for the measuring unit of the com-
ponent, to be shown in the measuring screen:
each character must be set separately.
1)
Set the text for the measuring unit of the span
gas: each character must be set separately.
1)
Select the measuring unit for the compo-
nent.
Available options: ppm, ppb, Vol%, Cu-
stom
Select the measuring unit for the span gas.
Available options: ppm, ppb, Vol%, Cu-
stom
Note!
Zero gas unit and zero gas unit text are al-
ways as congured for the component (rst
2 menu lines)!
Gas concentrations are internally calculated
as ppm. To use other units, the corresponding
factor must always be specied, e.g. 0.0001
to calculate from ppm to %.
2)
If necessary, enter an offset here, to be added
to the measured value.
2)
The last 2 lines show how the settings affect
the display of measurements.
Note!
Texts for units, and values for "Custom Fac-
tor" and "Custom Offset" are not checked for
plausibility. Any arbitrary value can be set.
1)
Conguring individual text strings is
permitted only, if "Unit" or "Span gas unit"
is set to Custom.
2)
"Custom factor" and "Custom offset" are
visible and editable only, if "Unit" or "Span
gas unit" is set to Custom. For all other
options, conversion factors and offsets are
pre-dened.

Emerson X-STREAM XE Specifications

General

Brand	Emerson
Model	X-STREAM XE
Category	Measuring Instruments
Language	English