Emerson X-STREAM XE - Page 248

Emerson Process Management GmbH & Co. OHG6-86
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
10/2012
6.2.3 Setup Menu
6.2.3.6.6 Setup Alarms Calculatorn
Specify up to four threshold levels:
"LoLo" and "Lo" levels are to be setup below
the expected calculator result range.
"HiHi"and "Hi" levels are to be setup above
the calculator result range.
See the gure to the left for details.
Switch On or Off the alarm monitor for the cur-
rent calculator (here: exemplary Calculator A).
Specify the hysteresis to be considered
around the threshold levels, to avoid oscilla-
ting alarms.
To view the current alarm states;
6-84
Any X-STREAM XE analyzer can be up-
graded with optional software packages to
provide four calculators (A ... D). The results
can be monitored to activate alarms.
Note!
This menu is available only, if a valid soft-
ware upgrade code has been purchased and
entered (
6-89 ).
For more information on calculators, see the
associated separate software features docu-
mentation.
Setup..
Alarms..
Calculator A..D
Calculator A
Alarm Monitor: On
LoLo Level: 50.000
Lo Level: 100.000
Hi Level: 400.000
HiHi Level: 600.000
Hysteresis: 1000
States..
Note!
The unit used for calculator results is taken
from the entry at SETUP - CALCULATOR (
6-107 ).