118 Functional description CG Drives & Automation 01-7318-01r1
11.8.3 Stored values [730]
The shown values are the actual values built up over time.
Values are stored at power down and updated again at power
up.
Run Time [731]
Displays the total time that the AC drive has been in the
Run Mode.
Reset Run Time [7311]
Reset the run time counter. The stored information will be
erased and a new registration period will start.
Mains time [732]
Displays the total time that the AC drive has been connected
to the mains supply. This timer cannot be reset.
Energy [733]
Displays the total energy consumption since the last energy
reset [7331] took place.
Reset Energy [7331]
Resets the energy counter. The stored information will be
erased and a new registration period will start.
Unit: 00:00:00 (hours: minutes: seconds)
Range: 00: 00: 00–262143: 59: 59
Default: No
No 0
Yes 1
NOTE:
After reset the setting automatically reverts to “No”.
Unit: 00:00:00 (hours: minutes: seconds)
Range: 00: 00: 00–262143: 59: 59
Unit: Wh (shows Wh, kWh, MWh or GWh)
Range:
0.0–1GWh,
Counter will restart at 0 after 1GWh
732 Mains Time
Stp hh:mm:ss<
Default: No
Selection: No, Yes
NOTE:
After reset the setting automatically goes back to “No”.
To Next Page
Loading...
Need help?
General