Emotron VFX 2.0 User Manual

48 Operation via the Control Panel Emotron AB 01-4429-01r2
9.7 Programming example
This example shows how to program a change of the Acc.
Time set from 2.0 s to 4.0 s.
The blinking cursor indicates that a change has taken place
but is not saved yet. If at this moment, the power fails, the
change will not be saved.
Use the ESC, Prev, Next or the Toggle keys to proceed and
to go to other menus.
Fig. 55 Programming example
Menu 100 appears
after power-up.
Press Next for menu
[200].
Press Next for menu
[300].
Press Enter for menu
[310].
Press Next two times
for menu [330].
Press Enter for menu
[331].
Keep key pressed
until desired value has
been reached.
Save the changed
value by pressing
Enter.
100 0rpm
Stp 0.0A
A
NEXT
200 MAIN SETUP
Stp
A
NEXT
300 Process
Stp
A
ENTER
310 Set/View Ref
Stp
A
NEXT
330 Run/Stop
Stp
A
ENTER
331 Acc Time
Stp 2.00s
A
331 Acc Time
Stp 2.00s
A
Blinking
ENTER
331 Acc Time
Stp 4.00s
A

Emotron VFX 2.0 Specifications

General

Brand	Emotron
Model	VFX 2.0
Category	DC Drives
Language	English