Endress+Hauser Proline Promass 83 - Page 133

Proline Promass 83 PROFIBUS DP/PA Trouble-shooting
Endress+Hauser 133
472 P: >< BATCH
QUANTITY
$: # 472
0x00
0x01
0x02
BAD Non Specific
(uncertain
status)
O.K.
Low
High
Batch Quantity Cause:
EPD calibration not possible as the fluid conductivity is
too low or too high.
– Underbatching:
The minimum quantity was not reached.
– Overbatching:
The maximum permitted batching quantity was
exceeded.
Remedy:
Underbatching:
1. Increase fixed compensation quantity.
2. 2. Valve closes too quickly with active after run
compensation. Enter smaller after run as mean
value.
3. If the batching quantity changes, the minimum
batching quantity must be adjusted.
Overbatching:
1. Reduce fixed compensation quantity.
2. Valve closes too slowly with active after run
compensation. Enter larger after run as mean value.
3. If the batching quantity changes, the maximum
batching quantity must be adjusted.
!
Note!
Please observe Note in error message No. 471
473 P: PROGRESS NOTE
$: # 473
0x80 GOOD O.K. O.K. Progress Note Cause:
End of filling process approaching.
The running filling process has exceeded the predefined
batch quantity point for the display warning message.
Remedy:
No measures required (if necessary prepare to replace
container).
474 P: MAX. FLOW
!: # 474
0x00
0x01
0x02
BAD Non Specific
(uncertain
status)
O.K.
Low
High
Flow Rate Cause:
Maximum flow value entered is overshot.
Remedy:
Reduce the flow value
!
Note!
Please observe Note in error message No. 471
571 P: BATCH RUNNING
!: #571
0x80 GOOD O.K. O.K. Batch running Batch running
572 P: BATCH HOLD
!: #572
0x80 GOOD O.K. O.K. Batch hold Batch hold
No. Device status message
(local display)
PROFIBUS measured value status Adv. diagnosis
message in
PROFIBUS
master
Cause/remedy
Quality code (HEX)
Quality status
Quality substatus
Limits