iPAK2 User Guide
1
Document change record
Copyright © 2019 ENTRON and/or its affiliates. All rights reserved.
The information in this manual is subject to change.
ENTRON assumes no responsibility for any errors that may appear in this manual.
ENTRON assumes no responsibility for any injury, loss or damage caused by improper
installation, use or application of the iPAK2 welding control
The reproduction, transmission or use of this document or contents is not permitted without
express authority from ENTRON
ENTRON's trademarks and trade dress may not be used in connection with any product or service
that is not ENTRON's, in any manner that is likely to cause confusion among customers or in any
manner that disparages or discredits ENTRON. All other trademarks not owned by ENTRON are
the property of their respective owners, who may or may not be affiliated with, connected to, or
sponsored by ENTRON.
Issue Date Comment
2.00 27-02-19 Initial release
2.00.01 13-06-19 Minor errata corrected
2.00.02 19-06-19 Corrected weld program time range.
2.01 8-08-19 Added Presqueeze to all modes
2.02 19-09-19 Added programable blanking. Added C-Monitor
2.03 27-02-20 Includes iPAK2v2. Modified Seam sequence. Modified Analog control. Added Retry
feature.
2.04 16-09-20
Changed description of 2
nd
-stage Once/Every configuration parameter
To Next Page
Loading...
Need help?
General
