Epson AcuLaser C2800 - Page 219

AcuLaser C2800/C2800D/C3800/C3800D Revision C
DISASSEMBLY/REASSEMBLY Disassembly/Reassembly 219
Confidential
KIT ROLL ASSY FEED SEC (RETARD)
KIT ROLL ASSY FEED SEC consists of three rollers; one is installed in the CASSETTE
ASSY 550 IOT and the other two in the FEEDER ASSY, and is provided in a set. When
replacing these rollers, be sure to replace them at one time.
1. Release the tabs on the left and right ends of the COVER RTD CST, and open the COVER RTD CST.
2. Release the tab on the KIT ROLL ASSY FEED SEC (RETARD), and remove the KIT ROLL ASSY
FEED SEC (RETARD) from the SHAFT RETARD.
B
Kmy03018EA
1)-1
1)-1
2)-1
2)-2
1)-2
KIT ROLL ASSY FEED SEC (RETARD)
HANDLE CST
1. Turn the CASSETTE ASSY 550 IOT over, release the two protrusions with a mini screwdriver or a
similar tool, and remove the HANDLE CST.
Install the HANDLE CST so that the ACTUATOR NO PAPER MSI is inserted into the
hole of the PLATE ASSY BOTTOM.
C
Kmy03204EA
1)-1
1)-1
1)-2
1)-2
HANDLE CST