Epson AcuLaser C2800 - Page 265

AcuLaser C2800/C2800D/C3800/C3800D Revision C
DISASSEMBLY/REASSEMBLY Disassembly/Reassembly 265
Confidential
ACTUATOR A
ACTUATOR B
1. Remove the three screws (silver, self-tapping, 8 mm) that secure the CHUTE ASSY REGI UPPER.
As the CHUTE ASSY REGI UPPER remains connected with a harness, be careful not to
overload the terminal areas of the harness and the connector.
2. Release the tab on the CHUTE ASSY REGI UPPER, and pull the left side of the CHUTE ASSY
REGI UPPER in the direction of the arrow.
When performing reassembly, pull the harness that is coming out of the right side of the
CHUTE ASSY REGI UPPER slightly to take up the slack out of the harness.
NEXT>>
A
Kmy03213EB
2)-2
2)-1
1)
1)
1)
3. Release the tab on the downside of the COVER ACTUATOR with a mini screwdriver or a similar
tool, and remove the COVER ACTUATOR by sliding it toward you.
4. Pull the shaft of the ACTUATOR A, B out of the tab on the CHUTE REGI, and remove the
ACTUATOR A, B together with the SPRING REGI SNSR A, B.
5. Release the SPRING REGI SNSR A, B that are hitched on the tabs of the ACTUATOR A, B, and
separate the ACTUATOR A, ACTUATOR B, SPRING REGI SNSR A, and SPRING REGI SNSR B.
Be sure to hitch the SPRING REGI SNSR A, B on the ACTUATOR A, B and the CHUTE
REGI.
3)-2
3)-1
4)
5)
4)
5)
5)
5)
Kmy03214EA
3)-1
ACTUATOR A
ACTUATOR B