AcuLaser C2800/C2800D/C3800/C3800D Revision C
DISASSEMBLY/REASSEMBLY Disassembly/Reassembly 287
Confidential
DRIVE ASSY MAIN
NEXT>>
A
D
Kmy03058EA
4)
5)
2)
2)
3)
7)
7)
6)-1
6)-2
7)
8)-1
8)-1
8)-2
7)
1. Release the harness of the HARNESS ASSY USB from the DUCT DRV MAIN.
2. Remove the two screws (silver, self-tapping, 10 mm) that secure the BRACKET FUSER to the main unit.
Do not pull the BRACKET FUSER too far from the main unit as they are connected with a
harness.
3. Remove the BRACKET FUSER from the main unit.
4. Release the harness of the DRIVE ASSY MAIN from the DUCT DRV MAIN.
5. Remove the screw (silver, self-tapping, 10 mm) that secures the DRIVE ASSY MAIN to the main unit.
6. Release the guide pin of the DUCT DRV MAIN, slide the DUCT DRV MAIN to the rear side of the
printer, and remove the DRIVE ASSY MAIN.
7. Disconnect the following connectors: connector of the MAIN MOTOR (P/J211) inside the DRIVE
ASSY MAIN, connector of the SUB MOTOR (P/J221), connector of the DEVE MOTOR (P/J222),
and connector of the EXIT CLUTCH (P/J2761).
8. Remove the clamp, which is attached to the DRIVE ASSY MAIN, together with a harness.
The harness of the connector to be connected to the DEVE MOTOR should pass the far side
of the tab on the DRIVE ASSY PH.
NEXT>>
To Next Page
Loading...
