196
Functions of the Control Panel
Before you start printing in the GL/2 mode
You may need to change the following print options in your
application, depending on your output needs. Check these
settings to make sure they match the data you are trying to print.
If you need to configure the printer settings, first switch to the
GL/2 emulation mode, then change the settings using the printer
driver, or the control panel menus.
Note:
Settings or data saved in the printer’s RAM (such as downloaded fonts)
may be erased when you change the emulation mode.
GL Mode
Specifies whether the printer uses a direct emulation of the GL/2
plotter language, or the HP LaserJet 4 emulation of GL/2.
Scale
Specifieswhetherthe output from the software isscaled. The scale
factor is based on the output paper size of the application.
Origin
Specifies whether the logical origin of the “plotter” is the corner
or the center of the paper.
Print Options Settings
Paper size Printer’s paper size setting
Driver (plotter selection) HP-GL/2 or HP-GL
Pen configuration Pen thickness
Plot origin Center or Corner
Orientation
GLlike
offers landscape only
LJ4GL2
offers landscape and portrait
To Next Page
Loading...
