Epson AcuLaser C8600 - GL2 Menu

Functions of the Control Panel
195
6
6
6
6
6
6
6
6
6
6
6
6
GL2 Menu
This menu lets you set the printer to emulate a plotter, allowing
you to use software that requires a plotter for output. LJ4GL2
mode is similar to GL/2 mode supported in the HP LaserJet 4
mode. The GLlike mode emulates some of the HP-GL plotter
commands and includes all the commands found in HP’sGL/2
mode, as well as two additional commands.
* Available only when
GLIike
is selected as the GL Mode.
Item Settings (default in bold)
GL Mode LJ4GL2, GLlike
Scale Off,A0,A1,A2,A3
Origin Corner,Center
Pen Pen0, Pen1, Pen2*, Pen3*, Pen4*, Pen5*,
Pen6*
End Butt, Square, Triangular, Round
Join Mitered, Miteredbeveled, Triangular, Round,
Beveled, None
Pen 0 0.05 to 0.35 to 5.00 mm in 0.05 increments
Pen1 0.05 to 0.35 to 5.00 mm in 0.05 increments
Pen2* 0.05 to 0.35 to 5.00 mm in 0.05 increments
Pen3* 0.05 to 0.35 to 5.00 mm in 0.05 increments
Pen4* 0.05 to 0.35 to 5.00 mm in 0.05 increments
Pen5* 0.05 to 0.35 to 5.00 mm in 0.05 increments
Pen6* 0.05 to 0.35 to 5.00 mm in 0.05 increments