Using Options
217
7
7
7
7
7
7
7
7
7
7
7
7
Removing the Large Capacity Paper Unit
The removal procedure for the optional Large Capacity Paper
Unit is the same as that for the 500-Sheet Paper Cassette Unit. The
illustrations below show an optional Large Capacity Paper Unit
with two paper cassettes.
Follow these steps to remove the Large Capacity Paper Unit or
the 500-Sheet Paper Cassette Unit:
1. Make sure the printer is not turned on, and unplug the power
cord if it is plugged into an electrical outlet.
2. Lock all casters at the bottom of the unit.
w
Warning:
You should lock all casters before removing the unit from the
printer. Otherwise, the unit may move and cause an accident.
3. Remove the left connector cover at the back of the printer by
sliding it down, then open the right cover underneath.
4. Disconnect the two cables from the connectors on the printer,
then close the right cover and reattach the left connector cover.
5. Remove the upper paper cassette from the unit.
6. Loosen the two screws on the top of the slot to release the unit
from the printer.
7. Reinsert the upper paper cassette back into the unit.
8. Gently lift up the printer until the holes on the bottom of the
printer are free from the three pins on the top of the unit.
w
Warning:
Four people should lift the printer by the correct positions as
shown under “Handling precautions” on page 211.
To Next Page
Loading...
