Epson AcuLaser C8600 - Printout Problems; The Font Selected in the Application Software; Will Not Print; Some or All of the Printout Is Garbled

Troubleshooting
301
10
10
10
10
10
10
10
10
10
10
10
10
Printout problems
The font selected in the application software will
not print
Some or all of the printout is garbled
Cause What to do
You may use the printer fonts
substituted for specified
TrueType fonts.
In the printer driver, choose the Print
TrueType fonts as bitmap radio button
intheExtendedSettingsdialogbox.
The selected font is not
supported by your printer.
Make sure that you have installed the
correct font. See “Available Fonts” on
page 363 for more information.
Cause What to do
The interface cable may not be
plugged in securely.
Make sure that both ends of the
interface cable are plugged in securely.
You may not be using the
correct interface cable.
If you are using the parallel interface,
make sure that the cable is a
double-shielded, twisted-pair interface
cablenomorethansixfeetinlength.
If you are using the USB interface, use a
Revision 1.1 compliant cable.
The emulation setting for the
port may not be correct.
Specify the emulation mode by using
the printer’s control panel menus. See
“Emulation Menu” on page 179.