326
Troubleshooting
Print Overrun
The required time to process the print data exceeded the print
engine speed because the current page is too complex. Press the
Start/Stop button
to resume printing. Or press the Job Cancel
button to cancel the print job. If this message appears again, select
On
as the Page Protect setting in the control panel’sSetupMenu.
If you continue to receive this message when printing a particular
page, try simplifying the page by limiting the number of graphics
or reducing the number and size of fonts.
You can also add more memory to the printer as described in
“Memory module” on page 351.
PS3 Hard Disk full
The memory allocated for writing PostScript 3 commands on the
optional Hard Disk Drive is full.
To clear this error, select
Clear Warning
from the control panel’s
ResetMenu.See“Howtoaccessthecontrolpanelmenus”onpage
167 for instructions.
RAM Check
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Replace Photoconductr
The photoconductor unit has reached the end of its service life.
Turn off the printer, then replace the photoconductor unit with a
a new one. See “Photoconductor Unit” on page 262 for
instructions.
To Next Page
Loading...
