Epson Expression 10000XL - Network Image Express Interface Card

Expression 10000XL Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 63
11. Remove the two screws (CBP M4 x 10) that are securing each of the Hinges, and
remove both Hinges.
Figure 4-63. Removal of Hinges

When reinstalling the Hinges, be sure to match the holes and
dowels indicated in Figure 4-63.

When reinstalling the Guide Rails, be sure to match the holes
and dowels indicated in Figure 4-62.

When reinstalling the Fixing Plate B, be sure to match the
holes and dowels indicated in Figure 4-61.

When reinstalling the Frame A, be sure to match the holes and
dowels indicated in Figure 4-60.

When reinstalling the Fixing Plate A, be sure to match the
holes and dowels indicated in Figure 4-59.
M4x10
(50±10Ncm)
Hinges
Positioning Holes and Dowels
Positioning Holes and
Dowels