All the text is printed on the same line.
Cause What to do
No line feed command is sent
at the end of each line of text.
Turn on the auto line feed setting using
the printer’s default-setting mode or
the EPSON Remote! utility so that the
printer automatically adds a line feed
code to each carriage return. See
“Making Default Settings” in Chapter
5, or “Using the EPSON Remote!
utility” in Chapter 2.
The printout has extra blank lines between lines of text.
Cause What to do
Two line feed commands are
being sent at the end of each
line of text.
Turn off the auto line feed setting
using the printer’s default-setting
mode or the EPSON Remote! utility.
See “Making Default Settings” in
Chapter 5, or “Using the EPSON
Remote! utility” in Chapter 2.
The line space setting in your
application software is
incorrect.
Adjust the line space setting in your
application software.
Printer prints strange symbols, incorrect fonts, or other
inappropriate characters.
Cause What to do
Your printer and computer
may not be communicating
correctly.
Make sure that you use the correct
interface cable and that the
communications protocol is correct.
See page 1-11 and your computer
documentation. If you installed the
optional serial interface card, also see
page 7-2.
8
Troubleshooting
R
Gentian Rev.c
A5 size Chapter 8
97/06/20 pass 1
Troubleshooting
8-11
To Next Page
Loading...
