Epson LX-300

LX-XXI Sarvka Manual
Product Description
1.2.1.1 Paper Handling Specifications
Feeding system:
Friction feed or tractor (push and pull) feed
Feeding method
Cut sheets:
Manual insertion (top entry) and feeding with the
optional cut sheet feeder
(CSF)
Continuous paper:
Push and pull tractor feeding
Feeding pitch:
li~ in~, 1A in~, or pr~ammable feeding in in~ments
of %16 inch, minimum
Paper paths
Cut sheet path:
Top entry (manual insertion or the
optioml CSF)
Continuous paper paths:
Rear entry (push tractor feed)
Rear entry (pull tractor feed)
Continuous paper parking:
Possible, using push tractor
CSF:
Single bin, manual insertion using optional
CSF (top entry)
Paper-feeding speed:
See Table 1-2.
Table 1-2. Feeding Speed
Feeding
l/G
inoh Line Feed
Continuous Feed
Friction
79 rns/line
2.78 incheskecond
Tractor (single)
Tractor (double)
96 redline
2.08 inoheakxond
Friction feed
● Set the release lever to the friction msition.
. When a sheet is inserted into the t;p slot, place its left edge at the marked position.
. Donotperform reverse feeds greater than O.27inch(6.8 mm).
Push tractor feed
. Set the release lever to the tractor position.
.
Donotperform reverse feeds greater than O.27 inch (6.8 mm).
. During printing ofiabels, never perforrnreverse feeding.
. After printing labels, do not eject them from the rear.
Pull tractor feed
0 Remove the tractor unit from the push position and mount it in the pull position.
● Do not perform reverse feeding.
The adjust lever must be set to proper position for the paper thickness, as shown below.
Table 1-3. Adjust Lever Settings
Lever Position Paper Thickness
o
0.065 mm -0.16 mm (0.0026 in. -0.0063 in.)
1 0.16 mm -0.25 mm (0.0063 in. -0.0098 in.)
2
0.25 mm -0.48 mm (0.0098 in. -0.0189 in.)
b
Rev. A
14