Epson RC90 User Manual

Maintenance 9. Troubleshooting
No.
Message
Remedy
Note 1
Note 2
1188
File failure.
Failed to save the backup information
file.
1189
The backup data was created by an old
version.
Cannot restore the controller
configuration in the specified procedure
for using old backup data.
Check the backup data.
1190
The backup data was created by a
newer version.
1191
There is no project in the backup data.
1192
Cannot execute with invalid robot
number.
1194
Cannot execute with invalid drive unit
number.
1193
Cannot execute with invalid robot
information.
1200
Compile failure.
Check the compile message.
This error occurs during compilation
from TP. Correct where the error
occurred.
1201
Link failure.
Check the link message.
This error occurs during compilation
from TP. Correct where
the error
occurred.
1250
User Outputs failure.
The Name is empty.
-
1251
User Outputs failure.
The Condition is empty.
-
1252
User Outputs failure.
Robot number is out of the available
range.
-
1260
Alarm Setting failure.
Robot does not exist.
-
1261
Alarm Setting failure.
Failed to get the expiration date.
-
1262
Alarm Setting failure.
Failed to set the alarm.
-
1263
Alarm Setting failure.
Specified alarm number is out of the
allowable range.
-
1264
Alarm Setting failure.
Specified alarm number is not enabled.
-
1500
Communication error.
1501 Command did not complete in time.
Execute the command again after a
while. Check the connection between
the EPSON RC+7.0 and controller.
1502
Communication disconnection
between RC+
and Controller.
Re-establish communication.
Check the connection between the
EPSON RC+7.0 and controller.
1:
Communicatio
n timeout
2: USB cable
disconnection
3: USB
reception
failure
4: USB
communicatio
n shutdown
RC90 (EPSON RC+ 7.0) Rev.4
123

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English