Epson RC90 - Page 170

Maintenance 9. Troubleshooting
No. Message Remedy Note 1 Note 2
3334
The number of variables
which is
using Wait command is
beyond the
maximum allowed.
3335
Call cannot be used in parallel
processing.
3336 Variable was redefined.
3400 Dialog ID was not specified.
3401 Main function name was not specified.
3402 Vision object name was not specified.
3403
Recover mode ID was not specified.
3404
Trap condition was not specified.
3405
DialogResult was not specified.
3406
MsgBox_Type was not specified.
3407
Byte type array variable was not
specified.
3408
Single array variable was not specified.
3409
Point list is not specified.
3410
Code type is not specified.
3411
Edge type is not specified.
3412
ECC type is not specified.
3413
ImageColor type is not specified.
3414
Point type is not specified.
3415
Reference type is not specified.
3416
Edge type is not specified.
3417
Port number is not specified.
3418
Axis is not specified.
3419
CompareType is not specified.
3420
Integer or Short type array variable is
only available.
3421
Form name or window ID is not
specified.
3422
Window ID is not specified.
3423
Performance mode ID was not
specified.
3424
Protocol type was not specified.
3425
I/O type or I/O label was not specified.
3426
Singularity avoidance mode was not
specified.
3427
Acceleration value was not specified.
3428
Acceleration value was not specified.
3429
Sorting order for work queue data was
not specified.
3500 Duplicate macro in #define statement.
Another macro with the same name has
been defined. Change the macro name.
3501 Macro name was not specified.
3502 Include file name cannot be found.
3503
Specified include file is not in the
project.
The include file that is not registered in
the project configuration is specified.
Add the include file to the project
configuration.
3504
Parameter of the macro function does
not match the declaration.
RC90 (EPSON RC+ 7.0) Rev.4
154