Epson RC90 - Page 171

Maintenance 9. Troubleshooting
No.
Message
Remedy
Note 1
Note 2
3505 Macro has a circular reference.
The macro has a circular
reference.
Correct the circular reference.
3506
#define, #ifdef, #ifndef, #else, #endif,
#undef and variable declaration
statements are only valid in an include
file.
3507 Over #ifdef or #ifndef nesting level.
Reduce the nesting level to under the
limited value.
3508
Cannot find corresponding #ifdef or
#ifndef.
3509 No #endif found for #ifdef or #ifndef.
3510 Cannot obtain the macro buffer.
3550
Parameter for the macro function was
not specified.
The macro declared as a macro function
is called without argument.
3600
Tracking motion command cannot use
Sense parameter.
3601
Parameter type is mismatch for the
external function ' ** '.
Check all statements where this
function is called in this file.
3602
The specified motion command cannot
use LJM parameter.
3603
InReal function cannot be used with
Wait statement.
3605
The specified motion command cannot
use PerformMode parameter.
3800 Compile process aborted.
3801 Link process aborted.
3802
Compile process aborted. Compile
errors reached the maximum count.
3803
Link process aborted.
Link errors
reached the maximum count.
3804
Specified command cannot be
executed from the Command window.
3805
Specified command can only be
executed from the Command window.
3806
Specified function cannot be executed
from the Command window.
3807
Specified command cannot be
executed in the Gripper function.
3808
Specified syntax cannot be used in the
current version.
3809
Module variables cannot be used in the
command window.
3810
Too many point files.
3811
Too many registered points.
3812
Specified function cannot be used with
a Remote User Output.
3813
User defined label, function and
variable cannot be used with a Remote
User Output.
RC90 (EPSON RC+ 7.0) Rev.4
155