Epson RC90 - Page 195

Maintenance 9. Troubleshooting
No.
Message
Remedy
Note 1
Note 2
7030
Specified point
label is beyond the
maximum length.
Specify a valid
point label.
Change the point label.
7031
Description for the specified point is
beyond the maximum length.
Specify a valid description.
Change the comment.
7032
Point file is corrupted. Check sum
error.
Create the point file again.
7033
Specified point file cannot be found.
Specify a valid point file name.
Check the name of the specified point
file.
7034 Cannot save the point file.
Failed to save the point file (create a
temporary file).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7035 Cannot save the point file.
Failed to save the point file (file open).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7036 Cannot save the point file.
Failed to save the point file (renew the
file header).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7037 Cannot save the point file.
Failed to save the point file (create the
file name).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7038 Cannot save the point file.
Failed to save the point file (copy the
file).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7039 Cannot save the point file.
Failed to save the point file (change the
file name).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
7040
The point label is not correct.
Specify a valid point label.
The initial character of the point label
name is improper. Correct the lable
name.
7041
The point label is not correct.
Specify a valid point label.
Inadequate character is used.
Correct the lable name.
7042 The pallet cannot be defined.
Undefined flag for pallet data is mixed.
Check the point data.
Correct the point data.
7043 Invalid point file version.
The point file version is different.
Re-create the point file.
7044 Point file not supported format.
The point file is not supported.
Re-create the point file.
7045
The specified work queue number is
invalid.
Check the specified work queue number.
7046 The specified work queue is full.
The work queue is full. Delete the
point data from the work queue and
register.
RC90 (EPSON RC+ 7.0) Rev.4
179