Before Reading This Manual
Do not connect the followings to the TP/OP port of RC90. Connecting to the followings
may result in malfunction of the device since the pin assignments are different.
OPTIONAL DEVICE dummy plug
Operation Pendant OP500
Operator Pendant OP500RC
Jog Pad JP500
Teaching Pendant TP-3**
Operator Panel OP1
F
or RC90, be sure to install the EPSON RC+ 7.0 to the development PC first, then connect
the development PC and RC90 with the USB cable.
If RC90 and the development PC are connected without installing the EPSON RC+ 7.0 to
the development PC, [Add New Hardware Wizard] appears. If this wizard appears, click
the <Cancel> button.
C
oncerning the security support for the network connection:
The network connecting function (Ethernet) on our products assumes the use in the local
network such as the factory LAN network. Do not connect to the external network such
as Internet.
In addition, please take security measure such as for the virus from the network connection
by installing the antivirus software.
S
ecurity support for the USB memory:
Make sure the USB memory is not infected with virus when connecting to the Controller.
To Next Page
Loading...
Need help?
General
