Using Your Printer with DOS
5-16
International Character Sets
You can select one of these international character sets using
default-setting mode (as described on page 5-3) or the ESC R
command (as described on page 5-17). When you select a
character set, such as Italic France, the characters in the France
row on the table below are used in the italic character table.
You can select one of these eight international character sets
using default-setting mode or ESC R.
You can select one of these seven sets using ESC R only.
usedos.fm5 Page 16 Friday, May 9, 1997 1:54 PM
To Next Page
Loading...
