Epson Stylus Color 1520 User Manual

Printing on Special Media
3-18
Removing Continuous Paper
When you’ve finished printing a continuous paper document,
you must carefully follow these steps to remove it from the
printer, depending on your media type and the setting of the
auto tear-off feature.
1. If the printer’s auto tear-off feature is turned on, your
continuous paper is automatically advanced to the tear-off
position at the end of a print job. Go to step 2.
If the auto tear-off feature is turned off (the default setting),
press the
LF/FF button as many times as necessary to
advance the last printed sheet to the tear-off edge. Go to
step 2.
If the auto tear-off feature is turned off (the default setting)
and you’re printing labels, tear off the next sheet of labels at
the back of the printer. Then press the
LF/FF button on the
printer’s control panel as many times as necessary to eject
the remaining pages forward out of the printer. Do not
perform steps 2 and 3.
Note:
See Chapter 5 for
information on using
default-setting mode to
change the auto tear-off
setting for your print job.
media.fm5 Page 18 Friday, May 9, 1997 1:48 PM

Epson Stylus Color 1520 Specifications

General

Color	Yes
Maximum resolution	600 x 1200 DPI
Print speed (black, normal quality, A4/US Letter)	- ppm
Maximum input capacity	100 sheets
Envelopes sizes	10, C5, DL
Standard media sizes	4\
Paper tray media types	Envelopes, Labels, Plain paper
Non-ISO print media sizes	Legal
ISO A-series sizes (A0...A9)	A4
ISO B-series sizes (B0...B9)	B5
Power requirements	120V AC, 50/60 Hz
Printing noise level	45 dB
Maximum operating temperature range (T-T)	-20 - 60 °C
Market positioning	Home & office