Printing on Special Media
3-33
10. Before printing on another type of paper, be sure to change
the
Paper Source, Paper Size, and Media Type settings
in your printer software as described in Chapters 1 and 2.
Also be sure to turn off banner mode using the
default-setting mode instructions on page 5-3.
If you’ll be printing on continuous paper, also be sure to
reset the paper release lever, as described on page 3-14.
Printing a Backlit Display
You can use EPSON Ink Jet Back Light Film to print crisp,
translucent images for backlit display. Your printer software
automatically makes a mirror image of your design so it appears
correctly when viewed from the reverse side. Follow the steps in
this section to load a sheet of back light film and select the
correct printer settings for a backlit display.
Loading Back Light Film
Before loading the back light film, make sure the sheet is flat. If
the film curls, place it between two sheets of paper and put a
heavy object on top to flatten it.
Load one sheet of back light film as follows:
◗ Load it in the built-in sheet feeder with the printable,
non-glossy, white surface face down following the
instructions on page 3-6.
◗ Load it in the manual feeder with the printable, non-glossy,
white surface face up following the instructions on
page 3-11.
media.fm5 Page 33 Friday, May 9, 1997 1:50 PM
To Next Page
Loading...
Need help?
General
