Using Your Printer with DOS
5-17
Characters Available with the ESC ( ^
Command
To print with the characters listed below, use the ESC ( ^
command as described in the next section.
Using Printer Commands
You can operate your printer by using commands in one of two
control code modes. For the best font and graphics control,
always use
EPSON ESC/P 2 mode. (For details on using
ESC/P 2, see the ESC/P Reference Manual available from
EPSON.)
If you need to emulate an IBM Proprinter, select IBM XL24E
mode. (See IBM’s X24/X24E reference manual.)
usedos.fm5 Page 17 Friday, May 9, 1997 1:54 PM
To Next Page
Loading...
