Printing on Special Media
3-11
Loading Paper in the Manual Feeder
You can load one single sheet of paper in the manual feeder
without removing paper from the built-in sheet feeder. Load
any type of paper that is between 4.1 inches (105 mm) and
17 inches (432 mm) wide.
1. Turn on the printer, but don’t send a print job before you
load paper in the manual feeder; always load paper first.
2. Set the paper release lever to the single sheet position (the
single sheet icon appears beneath the lever handle).
3. Open the printer cover and set the thickness lever to the 0
position when you print on plain paper, ink jet paper,
transparencies, transfer paper, or labels.
Set it to the + position when you print on envelopes, ink jet
cards, or heavy paper.
Note:
To load banner paper,
canvas cloth, or other roll
paper in the manual
feeder, you must also use
the optional Banner Paper
Kit. See page 3-22 for
instructions.
single sheet icon
0 position
+ position
media.fm5 Page 11 Friday, May 9, 1997 1:48 PM
To Next Page
Loading...
