Using Your Printer with DOS
5-4
3. Hold down the
Micro Adjust D button and press the
P
Operate button to turn on the printer and enter
default-setting mode. Release the
Micro Adjust
D button
when the
Operate light comes on.
The printer loads a sheet of paper and prints an instruction
sheet telling you how to select a language (the default
setting is English). The printer can then print
default-setting instructions in the language you choose.
4. Press the
Alt button until the Ink Out B and Ink Out A
lights on your control panel indicate the language you want
to use.
English Both lights off
French
Ink Out B on and Ink Out A off
Spanish Both lights on
Portuguese
Ink Out B flashing and Ink Out A on
German
Ink Out B flashing and Ink Out A off
Italian
Ink Out B off and Ink Out A on
5. Press the
Pause button. The printer prints instructions on
changing the default settings.
6. Follow the instructions on the sheets to change the
necessary settings, as listed in the next section. Your
changes remain in effect until you change them again.
(To exit without changing any settings, press the
Pause
button.)
7. When you’re finished changing settings, press
Load/Eject
if you need to eject any loaded paper. Then turn off the
printer to exit default-setting mode.
8. Wait five seconds, then turn on your printer to resume
printing normally.
usedos.fm5 Page 4 Friday, May 9, 1997 1:54 PM
To Next Page
Loading...
Need help?
General
