Epson T-B Series

T3-B T6-B Manipulator 6. Operation Mode & LED
T-B series Rev.1 89
6.5 LED
Six LEDs are located on the front panel of the Manipulator.
LEDs (ERROR, E-STOP, TEACH, TEST, AUTO, PROGRAM) turn ON according to the
Controller status (error, Emergency Stop, TEACH mode, Auto mode, Program mode).
LED
(Illustration: T3-B401S)
(Illustration: T3-B401S)
Controller status
LED display
Start up
(Required time is different
depending on the connection
status of the device.)
1. TEST, TEACH, AUTO, and PROGRAM blink (15
seconds)
2. All turn OFF (10 seconds)
3. All turn ON (to 10 seconds )
4. All turn OFF (10-30 seconds )
5. Either of TEACH, AUTO, or PROGRAM turns
ON
Execute Controller status
storage function to the
USB memory
TEACH AUTO, PROGRAM blink.
Complete Controller status
storage to USB memory
TEACH, AUTO, PROGRAM turn ON
(for 2 seconds).
ERROR turns OFF even if an error occurs.
Failure of Controller status
storage to USB memory
ERROR, TEACH, AUTO, PROGRAM turn ON
(for 2 seconds).
Error ERROR turns ON
Warning ERROR blinks.
Emergency Stop
E-STOP turns ON.
TEACH mode TEACH blinks.
Auto mode (AUTO mode) AUTO blinks.
Program mode (AUTO mode) PROGRAM blinks.
AC power supply drop TEACH, AUTO turn ON.
TEST mode TEST blinks.