Epson T-B Series

Installation 4. First Step
T-B series Rev.1 9
4. First Step
This section indicates the procedure to install the development PC EPSON RC+, and
execute simple program after connecting the development PC and Manipulator with a USB.
Make sure that the Robot system is installed safely by following the description in “1. Safety”
and “2. Installation”. Then, operate the Robot system in the following procedures.
4.1 Installing EPSON RC+ 7.0 Software
The EPSON RC+ 7.0 software needs to be installed on your development PC.
(1) Insert the EPSON RC+ 7.0 Setup DVD in the DVD drive.
(2) The following dialog will be displayed. Click <Next>.
(3) Enter your user name and company name and click <Next>.