150
When paper is loaded,
it is fed and an error
occurs
For Die-cut label
(Blackmark) and Con-
tinuous paper (Black-
mark)
The paper you are
using does not match
the [Media detection
settings].
Check the paper you are using and
the printer’s [Media detection set-
tings].
See "Media detection settings" on
page 115.
Black marks are out of
the specifications.
The black marks may not be
detected if their reflection rate is
higher than the specified value.
Infrared light is used to detect the
black marks; therefore, the reflec-
tion rate for the infrared light must
be lower than the specified value.
Check the black mark printing
specifications, and use the black
marks that match the printer speci-
fications. You may be able to
detect the black marks by perform-
ing [Adjust the Black Mark Detec-
tion Sensor].Click [Printer Setting
Utility] on the printer driver’s [Printer
Utilities] tab. When the PrinterSetting
screen is displayed, click [Printer
Adjustment] - [Sensor Adjustment]
and perform [Adjust the Black Mark
Detection Sensor].See "Sensor
Adjustment" on page 136.
An error has occurred
in the sensor.
If the printer has been working
properly so far, the sensor may be
malfunctioning. Contact your
dealer for repairs.
I want to use the large-
diameter roll paper
supply unit and take-
up unit
-
Use the large-diameter roll paper
supply unit and take-up unit that
match the printer specifications.
For the specifications of the large-
diameter roll paper supply unit and
take-up unit, see “TM-C3400/C3500
Series Design Manual for Media
Take-up Unit”.
For more information on “TM-
C3400/C3500 Series Design Manual
for Media Take-up Unit”, contact
your dealer.
-
Trouble Description Recovery method
Image/
Illustra-
tion
To Next Page
Loading...
Need help?
General
