228
When "Borderless Printing" is enabled
Top, bottom, left, right margins: 0 mm (Typical value)
If you enabled "Borderless Printing", printing is done with settings for no margins, but the
printing might protrude beyond the paper/label, depending on the actual print position
and the set position for the paper/label. To make sure printing does not protrude out,
ensure margins of 1.5 mm {0.06"} or more in the print data.
Even if "Borderless Printing" is enabled, the maximum value for the print area width is
104 mm {4.09"}.
Paper width
18.0 mm or more*2
Issuing pitch (Ph)
Auto-cut position
Auto-cut position
Paper feeding
direction
Print area
Label area
1.5 to 3.0 mm
0.5 to 1.0 mm
1.5 to 3.0 mm
Interval of perforated lines (Pm)
Perforated line
Center of paper width
Backing paper
Print area width
Edge cutoff 2.0 mm
Edge cutoff 2.0 mm
Auto-cut position
Perforated line
15.0 mm or more*1
Black mark
position
1.5 to 3.0 mm
*1 When auto cut is not performed: 8.0 mm or more
*2 When auto cut is not performed:11.0 mm or more
To Next Page
Loading...
