379
Code Condition/solution
120 Cannot communicate with a server using an open platform. Check the server or network
for errors.
201 The product's memory is full. You can send pages individually, or print received faxes and
delete them to free up memory space.
202 The line was disconnected by the recipient's fax machine. Wait a moment, then try again.
203 The product cannot detect a dial tone.
Make sure the phone cable is connected correctly and the phone line works. If you
connected the product to a PBX (Private Branch Exchange) phone line or Terminal
Adapter, change the Line Type setting to PBX. If you still cannot send a fax, turn off the
Dial Tone Detection setting. (Turning off the Dial Tone Detection setting may cause the
product to drop the first digit of a fax number.)
204 The recipient's fax machine is busy. Wait a moment, then try again.
205 The recipient's fax machine does not answer. Wait a moment, then try again.
206 The phone cable is incorrectly connected to the product's LINE and EXT. ports. Connect
the phone cable correctly.
207 The phone cable is not connected. Connect the phone cable.
208 The fax could not be sent to some of the specified recipients.
Print a fax log or Last Transmission report to check which recipients failed to receive the
fax. If the Save Failure Data setting is turned on, you can resend a fax from Job Status in
the Job/Status Menu.
301
401
There is not enough storage space available to save the data in the external memory
device. Clear space on the device, reduce the number of documents, or use a different
device.
302
402
The external memory device is write-protected. Disable write protection.
303 No folder is available for saving the scanned file. Create a folder or use a different
memory device.
304
404
An external memory device has been removed. Reinsert the device.
To Next Page
Loading...
