❏ Form
Set the number of lines for the selected paper size and orientation. is also causes a line
spacing (VMI) change, and the new VMI value is stored in the printer. is means that later
changes in the page size or orientation settings cause changes in the Form value based on
the stored VMI.
❏ CR Function
Select the line feed command when printing with a driver from a specic operating system.
❏ LF Function
Select the line feed command when printing with a driver from a specic operating system.
❏ Paper Source Assign
Set the assignment for the paper source select command. When 4 is selected, the commands
are set as compatible with the HP LaserJet 4. When 4K is selected, the commands are set as
compatible with the HP LaserJet 4000, 5000, and 8000. When 5S is selected, the commands
are set as compatible with the HP LaserJet 5S.
PS Menu:
❏ Error Sheet
Select On to print a sheet showing the status when an error occurs during PostScript or
PDF printing.
❏ Coloration
Select the color mode for PostScript printing.
❏ Binary
Select On when printing data that contains binary images. e application may send the
binary data even if the printer driver setting is set to ASCII, but you can print the data when
this feature is enabled.
❏ PDF Page Size
Select the paper size when printing a PDF le. If Auto is selected, the paper size is
determined based on the size of the rst page.
Auto Error Solver:
Select an action to perform when a 2-sided printing error or a memory full error occurs.
❏ On
Displays a warning and prints in single-sided mode when a 2-sided printing error occurs, or prints
only what the printer could process when a memory full error occurs.
❏ O
Displays an error message and cancels printing.
Memory Device Interface:
❏ Memory Device:
Select Enable to allow the printer to access an inserted memory device. If Disable is selected, you
cannot save data to the memory device with the printer. is prevents condential documents
from being removed illegally.
❏ File Sharing:
Select whether to give write access to the memory device from a USB-connected computer or a
network-connected computer.
Product Information
>
Settings Menu List
>
General Settings
383
To Next Page
Loading...
Need help?
General
