Epson XP-970 Series - Page 266

Related Information
& “Entering Characters” on page 25
& “Checking the Network Connection Status” on page 278
Making Wi-Fi Settings by Push Button Setup (WPS)
You can automatically set up a Wi-Fi network by pressing a button on the wireless router. If the following
conditions are met, you can set up by using this method.
❏
e
wireless router is compatible with WPS (Wi-Fi Protected Setup).
❏ e current Wi-Fi connection was established by pressing a button on the wireless router.
1.
Tap
on the home screen.
2.
Tap Wi-Fi (Recommended).
If the printer has been already connected by Ethernet, tapRouter.
3.
Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change Settings to
change the settings.
If the printer has been already connected by Ethernet, tap Change to Wi-Fi connection., and then tap Ye s
aer conrming
the message.
4.
Tap Push Button Setup (WPS).
5.
Hold down the [WPS] button on the wireless router until the security light
ashes.
If you do not know where the [WPS] button is, or there are no buttons on the wireless router, see the
documentation provided with your wireless router for details.
6.
Tap Start Setup.
7.
Tap Close.
e
screen automatically closes
aer
a
specic
length of time if you do not tap Close.
Adding or Replacing the Computer or Devices > Re-setting the Network Connection > Making Wi- …
266