Ericsson Redback Networks SmartEdge 1200 - Page 177

Index 5
initiating session, 5-34
LED behavior, 5-36
test levels, descriptions, 5-33
test parameters, 5-33
traffic cards supported, 5-32
operations connections, listed, 1-3
P
physical specifications, 3-6
pin assignments
10/100 Ethernet crossover cable, A-6
10/100 Ethernet straight cable, A-7
Craft console cable, A-2
Ethernet management port
crossover cable, A-2
straight cable, A-3
external timing cable, A-4
FE-GE breakout cable, A-7
POD (power-on diagnostics)
described, 5-12
displaying results, 5-13
enabling, 5-13
power
cables
connecting, 4-16
requirements, 3-5
chassis component data, 3-4
connecting chassis ground cable, 4-14
LEDs, 5-3
minimum circuit capacity, 3-5
protection ratios, listed, 1-3
traffic card data, 3-3
troubleshooting
A1 or A2 LED is not lit, 5-30
B1 or B2 LED is not lit, 5-30
powering off the system, 6-1
powering on the system, 5-2
R
rack, dimensions, 3-8
real-time clock, 1-9
recessed mount, 3-10
redundancy, 1-11
reload operations, management port restriction, 3-13
REM LEDs, ATM cards, 5-8
remote console
connecting cables, 4-31
equipment requirements, 3-14
uses, 4-28
repairing cards, restriction, 6-2
replacing cards, operating environment, 6-1
RUs (rack units), listed, 4-5
S
screws
air ramps
installing, 4-13
mounting brackets, 4-11
chassis
installing, 4-10
mounting brackets, 4-7
service clearances, 3-5
servicing cards, restriction, 6-2
SFP (small form-factor pluggable) transceivers
inserting, 6-6
removing, 6-6
site requirements
electrical, 3-3
environmental, 3-5
service clearances, 3-5
slot assignments, 4-20
slot restrictions
controller cards, 4-20
traffic cards, 4-20
SPD LEDs
10/100 Ethernet cards, 5-10
FE-GE cards, 100/1000 ports, 5-10
specifications
10/100 Ethernet cards, 2-8
ATM OC-12c/STM-4c cards, 2-4
ATM OC-3c/STM-1c cards, 2-6
chassis, 3-8
electrical, 3-3
environmental, 3-5
FE-GE cards, 2-8
Gigabit Ethernet cards (transceiver-based)
10GE cards, 2-14
GE1020 cards, 2-13
GE3 cards, 2-11
GE cards, first version, 2-10
GE cards, second version, 2-10
OC-192c/STM-64c cards, 2-16
physical, 3-6
SPEED LEDs, controller cards, 5-6
SSU (synchronization supply unit),
external timing source, 1-4
startup operations, management port restriction, 3-13
STDBY LEDs
ATM cards, 5-7
controller cards, 5-5
OC-192c/STM-64c cards, 5-12
synchronization, 1-3
SYNC LEDs
controller cards, 5-6
LED is not lit, 5-31
system
alarm LEDs, 5-4