AT Commands Phone Terminal Terminated 101
AT+CMGW Write Message To Memory
<toda>: GSM 04.11 TP-Address Type-Of-Address octet; in integer format.
<toda> Description
129 ISDN / telephony numbering plan, national/international
unknown
Default setting if ‘+’ is not in <da>
145 ISDN / telephony numbering plan, international number
Default setting if ‘+’ is in <da>
161 ISDN / telephony numbering plan, national number
128-255 Valid values, see GSM 04.08 section 10.5.4.7
<mr>: Integer; GSM 03.40 TP-Message-Reference.
Description: Stores a message to message storage <mem2> (see AT+CPMS). The memory location
<index> of the stored message is returned. By default, message status will be set to
‘stored unsent’, but parameter <stat> also allows other status values. If writing fails,
+CMS ERROR is returned.
Execution command: AT+CMGW=<length>[,<stat>]
<pdu><‘ctrl-z/ESC’>
Execution command
response:
+CMGW: <index>
Test command: AT+CMGW=? Shows if the command is supported.
Parameters:
<length>: Integer; with AT+CMGF=’0’, this value indicates the length of the actual TP data
unit (in octet units).
<stat>:
<stat> Description
0 Received unread (new) message
Default setting
1 Received read message
2 Stored unread message (only applicable to SMs)
3 Stored sent message (only applicable to SMs)
<pdu>: In case of SMS: GSM 04.11 SC address followed by GSM 03.40 TPDU in
hexadecimal format. ME/TA converts each octet of TP data unit into two
IRA-character long hexadecimal numbers.
In case of CBS: GSM TPDU in hexadecimal format.
<index>: Integer; value in the range of location numbers supported by the associated memory.
To Next Page
Loading...
