Ericsson T39 - WAP Browsing Options

AT Commands Phone Terminal Terminated 68
4.17.1 Commands
AT+CPAS Phone Activity Status
4.17 Ensemble S9: GSM Mobile Equipment, Control, and Status
Description: Returns the activity status <pas> of the ME. It can be used to interrogate the ME
before requesting action from the phone. If the command is executed without the
<mode> parameter, only <pas> values from 0 to 128 are returned. If the <mode>
parameter is included in the execution command, <pas> values from 129 to 255 may
also be returned.
Execution command: AT+CPAS[=<mode>]
Execution command
response:
+CPAS: <pas>
Test command: AT+CPAS=? Shows if the command is supported.
Test command
response:
+CPAS: (list of supported <pas>s)
Parameters:
<mode>:
<mode> Description
1 Allows the CPAS to return Ericsson-specific <pas> values
Default setting
<pas>:
<pas> Description
0 Ready (ME allows commands from TA/TE)
3 Ringing (ME is ready for commands from TA/TE, but the
ringer is active)
4 Call in progress (ME is ready for commands from TA/TE,
but a call is in progress)
129 MMI is in idle state. This is a sub-state to ‘ready’ (0) and has
the following definition:
• MMI in idle state, meaning that operator, clock, and date
is shown on the display
• No conversation or data call in progress
• No sub-menus shown on the display
• Only digits, ‘clear’, ‘*’, ‘NO’, and ‘#‘ allowed in this state
130 Mobile-oriented call in progress. Sub-state to ‘Call in
progress’ (4)
131 Mobile-terminated call in progress. Sub-state to ‘Call in
progress’ (4)