AT Commands Modem Terminated 204
5.14.1 Commands
AT*EOBEX Object Exchange
2 Registered, but ME is searching for a new operator to
register to
3 Registration denied
4 Unknown
5 Registered, roaming
<lac>: String; two byte location area code in hexadecimal format.
<ci>: String; two byte cell ID in hexadecimal format.
5.14 Ensemble S27: OBEX
Description: Starts an OBEX session. When the remote client sends AT*EOBEX, the modem tries
to connect to the OBEX server. If successful, CONNECT is returned. If the CONNECT
response is received, the client can start sending OBEX frames. If unable to connect,
the response NO CARRIER is returned.
The modem connection always returns from OBEX mode when the OBEX session is
ended.
Note: This command is abortable. An OBEX frame containing a disconnect code must
be sent. The hexadecimal code for disconnect is ox81. This code must be sent in an
OBEX frame and the hexadecimal value for the frame is 0x810003.
Execution command: AT*EOBEX
Test command: AT*EOBEX=? Shows if the command is supported.
<stat> Description
To Next Page
Loading...
