Ericsson T39 - Phone Profiles; Selecting Phone Profiles

AT Commands Phone Terminal Terminated 77
AT*ERIL Ring Level Set
AT*ERIP Ring Signal Playback
Description: Sets the volume for the ring signal used for incoming voice, Line 1 and Line 2, fax, and
data calls.
Set command: AT*ERIL=<volume>[,<call_type>[,<place>]]
Read command: AT*ERIL?
Read command
response:
*ERIL: <volume1>[,<call_type1>[,<place1>]]<CR><LF>
*ERIL: <volume2>[,<call_type2>[,<place2>]]<CR><LF>
...
*ERIL: <volumen>[,<call_typen>[,<placen>]]
Test command: AT*ERIL=? Shows if the command is supported.
Test command
response:
*ERIL: (list of supported <volume>s),(list of supported <call_type>s),
(list of supported <place>s)
Parameters:
<volume>:
<volume> Description
0 Off
1-6 Volume setting; no increasing ring
129-134 Volume setting; increasing ring
<call_type>:
<call_type> Description
1 Line 1
Default setting
2 Line 2
3 Fax
4 Data
<place>:
<place> Description
0 Hand-held
Default setting
1 Car mounted
Description: Plays one of the sound types available as a ring/message signal in the phone.
Set command: AT*ERIP=<volume>,<sound_type>
Test command: AT*ERIP=? Shows if the command is supported.
Test command
response:
*ERIP: (list of supported <volume>s),(list of supported <sound_type>s)